Hi all,

Does anyone have experience with enameling thin sheet of metal? Something like 34 gauge? Does it warp easily? Any trick to straighten it?

Context: I am thinking of trying my hands in watch dial, but a watch dial can't be thicker than 0.7mm, preferable under 0.5mm. I am looking to see how to extend this, but the thinner the piece the better. Wondering if anyone has experience with this.

Thanks!

For watch dial thickness must be 0,80 +/-0.05 minimum. The copper plate used is 0.20-0.22 thick.
Regards

Absolutnie się nie zgadzam że cyferblat musi mieć grubość 0,8 mm.

Robię cyferblaty o grubości 0,5 mm / używam srebra o grubości 0,3 mm.

Na zdjęciu cyferblat o grubości 0,5 mm w obudowie firmy parnis.

 

Pozdrawiam Leszek